1. Remove the internal screw and apply thread
locker (blue Loctite recommended) and re install the set screw inside the large screw. Make sure
to screw down the internal screw all the way in so that the tip just
protrudes.
2.
Remove the factory grip screw and lock washer from the grip of your
rifle. Be careful of the spring and detent for the safety as they may come out
if you remove the grip completely.
3. With the hammer cocked and
the gun on safe, insert the Trigger Adjustment Screw into the grip and
tighten the large screw until the pistol grip is
secure
4. Using the supplied hex wrench, tighten the
internal screw inside the grip screw until the it stops. DO NOT OVER
TIGHTEN. Back out the internal screw 1/4 turn at a time until the
safety lever can by actuated. Verify that the trigger, disconnector,
hammer and safety function correctly. Let your thread locker
dry before putting your rifle to use.
